Weather Stations

  Forum Menu

  Fine Offset weather stations > Troubleshooting > WS1081 not coming out of registration mode

First Post: Sun, 30 Mar 2014 11:23 am WS1081 not coming out of registration mode
Last post: Fri, 30 Aug 2019 11:08 am

Guest User
After inserting its batteries the Weather Station unit of my new WS1081 appears to stay in the ‘transmitter registration’ mode. This means the touch screen is never being enabled.

The manual says that the weather station will not allow the touch screen to be used until it has completed the transmitter registration process (also referred to as the ‘learning mode’) and that, after that process is complete, it will automatically switch to the normal display mode which allows the user to perform further setup using the touch screen.

Data from the transmitter is successfully being displayed on the weather station screen. Within a minute of inserting the batteries in the Weather Station unit, the outside temp & humidity, wind speed & direction, rainfall all begin being displayed, so the weather station is receiving data from the transmitter.

Even though data is being received from the transmitter and displayed, the “On/Off”, the “+” and the “-“ are not displayed on the screen, and the touch screen is not active. So it appears it is never coming out of the registration mode.

I have removed & replaced the batteries in each unit several times to reset the units, and in different orders, and there’s no change, the problem is consistently as describe above.

Has anyone seen this problem?
Sun, 30 Mar 2014 11:23 am
Report Post | Anchor
Guest User
Has anyone had problems with it not resetting to zero Sun, 18 May 2014 08:26 pm
Report Post | Anchor

  Post a reply message

Your name/nickname: Already registered? Please log in.
Message Text:
To ensure you are a human, enter the code as you see it above.
You are not logged in. This thread allows you to post messages anonymously, however, you will not be able to edit the message afterwards. Furthermore, you must wait at least 20 minutes before you can post again.